Quality Question Bank
for Exam preparation

Q2. ______________ can be defined as small subset of a lot.

1. Defect
2. Fraction Acceptable
3. Sample
4. Acceptance Number

Q3. What does the lean manufacturing aims to?

1. Outsource much of our manufacturing in order to focus on final assembly
2. Produce goods using less resources compared to mass production techniques
3. Produce products with fewer options to simplify consumer choices
4. Keep labor costs as low as possible by using more of other resources

Q4. Which of the following is the correct combination of specifications while designing a control chart:

1. Sample size, Frequency of sampling, specification limit
2. Sample size, Frequency of sampling, Number of defects
3. Sample size, Specification limit, process standard deviation
4. Sample size, Process mean, specification limit

Q5. In DMAIC, redesigning of process to either remove bottlenecks or to reduce waste takes place in the ______________ stage.

1. Define
2. Measure
3. Improve
4. Control

Q6. A structured tool, usually industry or activity specific, used to verify that a set of required steps has been performed is called:

1. Quality Policy
2. Check list
3. Trend analysis
4. Pareto diagram

Q7. A maturity model can be used as a benchmark for comparison and as an aid to understanding

1. TRUE
2. FALSE
3. depends
4. can't say

Q8. Which type of OEE category does component jam is classified into?

1. Quality loss
2. Downtime loss
3. Speed Loss
4. Depends upon the duration of component jam

Q9. A series of consecutive points on the same side of the average is called:

1. Run
2. Trend
3. Outliers
4. Cycle

Q10. According to ISO 9001:2015, organizational knowledge shall be

1. Documented and such documented information shall be maintained
2. Available to everybody
3. Determined to achieve conformity in products and services
4. All of the above
5. None of the above