Quality Question Bank
for Exam preparation

Quality- Q2. What is not part of set up reduction?

1. Keeping tools and gages in kits
2. Adding adjustments to fixtures and tools
3. Mistake proofing setup activities
4. Defining internal and external tasks

Quality- Q3. The defect concentration diagram can be used in the ______________ stage of the DMAIC.

1. Define
2. Measure
3. Analyze
4. Improve

Quality- Q4. The x bar chart monitors:

1. Between sample variability
2. Within sample variability
3. Instantaneous variability
4. Natural variability

Quality- Q5. X bar should never be interpreted when:

1. R chart shows out of control points
2. X bar chart shows out of control points
3. The process mean is not known
4. None of the above

Quality- Q6. Let p0 be the incoming fraction defective and p1 be the outgoing fraction defective (Assume both p1 and p0 is greater than 0). If rectifying inspection is performed then:

1. P0
2. P1
3. None of the above
4. Cannot be determined

Quality- Q7. –––––––– are the charts that identify potential causes for particular quality problems.

1. Control Chart
2. Flow chart
3. Cause and Effect Diagram
4. Pareto chart

Quality- Q8. The probability distribution function corresponding to tossing of a coin will be a:

1. Probability Density function
2. Probability Mass function
3. Probability Measurement function
4. Probability Cumulative Function

Quality- Q9. Provides relationship between two variables, and provides a visual correlation coefficient

1. Scatter Diagram
2. Cause and effect chart
3. Box plot
4. Multivari chart

Quality- Q10. ______________ diagram is used for identifying potential relationship between two variables.

1. Pareto
2. Ishikawa
3. Histogram
4. Scatter