Quality Question Bank
for Exam preparation

Q2. The thickness of aluminum sheet is specified to be of 6±2 mm. The Upper Specification Limit and Lower Specification Limit for the sheet are:

1. 4mm, 8mm
2. 8mm, 4mm
3. 6mm, 8mm
4. 4mm, 6mm

Q3. Let p0 be the incoming fraction defective and p1 be the outgoing fraction defective (Assume both p1 and p0 is greater than 0). If rectifying inspection is performed then:

1. P0
2. P1
3. None of the above
4. Cannot be determined

Q4. The focal point of all quality control should be:

1. Price focus
2. Cost Focus
3. Customer Focus
4. Manufacturing Focus

Q5. The process of evaluating overall project performance on a regular basis to provide confidence that the project will satisfy the relevant quality standards is called:

1. Quality Assurance
2. Quality Control
3. Quality Planning
4. Quality Review

Q6. Which of the following statements best characterizes the quality management practice called benchmarking?

1. The difference between grade and quality
2. The measurement of customer satisfaction
3. The ISO term for progress measurement
4. Comparing planned project practices to those of other projects
5. A technique used to test certain types of electronic equipment

Q7. You obtained a significant test statistic when comparing three treatments in a one-way ANOVA. In words, how would you interpret the alternative hypothesis H(a)?

1. All three treatments have different effects on the mean response.
2. Exactly two of the three treatments have the same effect on the mean response.
3. At least two treatments are different from each other in terms of their effect on the mean
4. response.
5. None of these

Q8. Statistical sampling is a method to determine the conformance to requirement for some element or product of a project. The advantage of statistical sampling is that it ______________.

1. is a good tool o gain customer confidence during a period of high rejects
2. does not require an expenditure of resources
3. is accurate enough with a sampling of less than one percent
4. does not require 100 percent sampling of the elements to achieve a satisfactory inference of the population
5. needs to be conducted only when there is a problem discovered with the end product or when the customer has some rejects

Q9. Which of the following is not true regarding when to select a p, c or u chart:

1. The process is a complex assembly operation and product quality is measured in terms of the occurrence of nonconformities, successful or unsuccessful product function, and so forth.
2. Process control is necessary, but measurement data cannot be obtained.
3. A historical summary of process performance is necessary.
4. Destructive testing (or such other expensive testing procedures) is required.

Q10. Learn how to tell when nothing can be gained from further discussion. This refers to which of the following discussion skills in meetings?

1. Acting as gatekeepers
2. Closing the discussion
3. Asking for clarification
4. Testing for consensus